NOTE: A drive must be at least 512 megabytes (MB) in size to be converted to the FAT32 file system. When the conversion is complete, click Finish.Īt a command prompt, type cvt drive: /cvt32 and then press ENTER, where drive is the drive you want to convert to the FAT32 file system.įor more information about the FAT32 file system, see the following article in the Microsoft Knowledge Base:ġ54997 Description of the FAT32 File System In the Drives box, click the drive you want to convert to the FAT32 file system.Ĭlick Next, click Next, and then click Next again. NOTE: Before you convert to the FAT32 file system, uninstall any utilities or tools that protect or encrypt the Master Boot Record (MBR) or partition table (for example, uninstall Bootlock included with Symantec Norton Your Eyes Only).Ĭlick Start, point to Programs, point to Accessories, point to System Tools, click Drive Converter (FAT32), and then click Next. To convert a drive to the FAT32 file system, use the following steps. Also, this procedure does not work if your hard disk has bad sectors. WARNING: After you convert your hard disk to FAT32, you are unable to convert it back to the original FAT system. In the Drives box, click the drive you want to convert to the FAT32 file system. That is not in spec of FAT32.This article describes how to convert a hard disk that uses the File Allocation Table (FAT or FAT16) file system to the FAT32 file system using Drive Converter. Click Start, point to Programs, point to Accessories, point to System Tools, click Drive Converter (FAT32), and then click Next. Now, let's look at the FAT Table sector size on the drive at offset 0x24. /rebates/&252fpartition-master252fformat-usb-flash-drive-to-fat32.
It's the same as Linux reports: thinkpad :: ~ % cat /sys/block/sdb/sdb1/size Next, I look at the total number of sectors in the FAT32 volume ID: uint32_t DskSize = 30734336 at offset 0x20 Then, on my Linux box, I dump 1GB of the flash to file and open it in a hex editor and get the following values: uint16_t BPB_ResvdSecCnt = 32 at offset 0圎 I fill my Kingston DTR30G2 up to 1GB with zeros and plug it into a Windows 7 box, and format it as FAT32.
0 kommentar(er)
